вторник, 21 ноября 2017 г.

WorkoutLabs Fit

WorkoutLabs Fit

Tap an exercise or swipe left to begin


Wide-Grip Lat Pulldowns / Pull Downs / Pullovers


Wide-Grip Lat Pulldowns / Pull Downs / Pullovers

  1. Set up a cable station with a straight bar attached to the top pulley.
  2. Sit on the seat facing the station. Keep your feet flat and planted firmly on the floor.
  3. Using an overhand grip, hold the bar as wide as comfortable. (Your hands should be about 1 1/2 – 2 times body width apart.)
  4. Lean back slightly without arching your back.
  5. Pull the bar towards the top of your chest using your shoulders while arcing your elbows out to the sides of your body.
  6. At the end of the movement squeeze you shoulders together slightly and hold for a count of one.
  7. Return to the start position by arcing your elbows forward while relaxing your shoulders.
  8. Repeat.

Seated / Low Cable Back Rows


Seated / Low Cable Back Rows

  1. Connect a V-bar attachment to the low pulley on a cable station or cable rowing machine.
  2. Sit down at the station and place your feet on the foot pads or crossbar provided, while keeping your knees slightly bent.
  3. Lean forward, keeping your back straight and grip the V-bar handles with both hands.
  4. Keeping your arms fully extended pull back until your torso is at a 90-degree angle from your legs.
  5. Your back should be slightly arched, with your chest should be pushed out. This is the start position.
  6. Keeping your torso stationary, pull the handles back towards you while squeezing your back muscles.
  7. Keep your arms close to your sides until your hands reach your abdomen. Exhale as you perform this movement.
  8. Hold for a count of one.
  9. Inhale as you return to the start position in a smooth movement.
  10. Repeat.

Do not swing or rock back and forth as you perform this exercise. Doing so can cause lower back injury. You can perform this exercise using a straight bar instead of a V-Bar. You can use an underhand or overhand grip.


Barbell Deadlifts


Barbell Deadlifts

  1. Place a barbell in a clear space on the floor. (Make sure there are no obstructions in your way.
  2. Stand facing the barbell with your legs about 4-6 inches from the bar.
  3. Place your feet shoulder width apart.Your feet can be pointed straight ahead or turned outwards slightly.
  4. Squat down, keeping your back straight and grip the bar with an overhand grip at shoulder width.
  5. Keep your arms fully extended and stand up with the barbell.
  6. As you lift the barbell, your hips and shoulders should rise together and your back should be straight.
  7. As you reach the top of the lift and are standing straight, rotate your shoulders back slightly until you feel a slight stretch in them.
  8. Lower the barbell back to the floor in the same squatting motion you used to lift it.

This exercise can be very dangerous if performed incorrectly. If you are a novice, only perform this exercise with an experienced trainer's supervision.


Single / One Arm Dumbbell Bench Rows


  1. Place a dumbbell on each side of a flat bench.
  2. Place your right knee on the end of the bench.
  3. Bend your torso from the waist until your upper body is parallel to the floor, while placing your right hand on the bench in front of you for support.
  4. With your left hand, pick up the dumbbell with an overhand grip. The palm of your hand should be facing into you.
  5. Keep your lower back straight. This is the start position.
  6. Using your back muscles, pull the dumbbell straight up to the side of your chest, keeping your upper arm close to your side. Exhale as you do so.
  7. At the top of the movement, hold for a count of one and squeeze your back muscles.
  8. Return to the start position inhaling as you do so. Repeat.
  9. Complete all repetitions for one side before switching sides.

This exercise can be performed using a cable station, with a stirrup handle attached to either the high or low pulley.


Straight Arm Pulldowns / Pull Downs / Pullovers


  1. Stand with feet shoulder-width apart. Keep the lower back straight and the core tight. Reach up and grab a pull-down bar with a wide grip.
  2. Keeping your arms straight with a very slight bend in the elbow, pull the bar down to your hips. Breathe out and flex your lats as you do so.
  3. Pause and slowly return to the top of the movement. Do not let the weight rest against the stack. Repeat the movement.

Bent Over Barbell Rows


  1. Set up a barbell on the floor and stand facing it with your legs slightly wider than shoulder width apart and your knees slightly bent.
  2. Bend forward at your waist and grip the barbell with an overhand grip.
  3. Keep your back straight and nearly parallel to the floor.
  4. Keep your head and neck straight. This is the start position.
  5. Without moving your torso, exhale and lift the barbell up towards you.
  6. Keep your elbows close in to your bodyand use your forearms to support the weight.
  7. At the top of the movement, hold for a count of one and sqyeeze your back muscles.
  8. Return to the start position inhaling as you do so.

If you suffer from lower back problems, this exercise is not recommended. Always keep your back straight throughout this exercise. This exercise can be performed using an underhand grip to engage the triceps also.


Back Extensions / Hyperextensions


  1. Lie face down on a hyper extension bench with your upper thighs and lower hips on the support pad. You must be able to bend at the waist freely.
  2. Lock your ankles under the footpads.
  3. Start with your body in a straight line head to toe.
  4. Place your arms across your chest, behind or at the side of your head.
  5. Slowly bend forward by relacing your, back and abdominal muscles.
  6. Continue as far as possible without rounding your back or raising your thighs from the support pad. You should feel a slight stretch in your hamstrings.Hold for a count of one.
  7. Return to the start position by contracting your back and abdominal muscles until your body is once again straight. Do not arch your back up at the end of the movement. Pause and repeat.

As your strength and flexibility increase, you can hold a weight plate against your chest for extra resistance.


Pull-ups


  1. Standing under a pull up bar, reach up and hold onto the bar with an overhand grip. Make sure your hands are about twice your shoulder width apart.
  2. Keep your arms straight and hang from the bar so that your arms are taking all of your weight.
  3. Keeping your body straight and not swinging your weight, pull your body up towards the bar by pulling your elbows down towards your torso at an angle.
  4. Continue lifting until your chest is nearly touching the bar. You should feel a “squeeze” at the base of your lats (about midway down your back and to the side) as they contract.
  5. Once your lats have completely contracted at the top of the movement, slowly lower your body to the starting position.
  6. Repeat.

By using a wide grip, your lats are doing most of the lift, rather than your biceps. It doesn't matter if you keep your legs straight or bent at the knees with your feet crossed. The important thing is that you do not use your legs to assist in lifting your body weight. As your strength increases, you can add weight by using a weight belt.


Dumbbell Incline Bench Rows


  1. Lean forward into an incline bench
  2. Using a neutral grip, hold a dumbbell in each hand so your palms are facing in.
  3. Your arms should be fully extended and hanging straight down. This is the start position.
  4. Pull your shoulder blades back and flex your elbows to pull the dumbbells up to your sides.
  5. Hold and squeeze your shoulder and back muscles.
  6. Return to the start position in a slow, controlled movement.
  7. Repeat.

Barbell Good Morning


  1. Using a squat or barbell rack, set the barbell at shoulder height.
  2. Position yourself so the barbell is resting on your shoulders and you are facing away from the rack.
  3. Stand up to lift the barbell clear of the rack and take a few steps away from the rack.
  4. Position your feet slightly less than shoulder width apart.
  5. Keep your legs straight and bend forward at the hips.
  6. Continue bending forward until you feel a mild stretch in your hamstrings. (Do not try to bend past the mild stretching sensation. As flexibility increases so does the range of motion.) Hold for a count of one.
  7. Return to the starting position by straightening from the hips. Repeat.

Start with lower weights when performing this exercise for the first few times to allow your body to adapt to the movement. This exercise can also be done with your knees slightly bent to emphasize use of your glutes.


Liked this workout?


Find the perfect plan for you at


Original article and pictures take workoutlabs.com site

Комментариев нет:

Отправить комментарий